Spare parts for smartphones, tablets... English USD

Repair guide : Battery iPhone 6S

Level : Medium Time : 25 min Author : Alexandre
860 people have done this repair successfully ! Why not you?
This guide is for replacing the battery of the iPhone 6S.
Symptoms : Low life battery, phone does no turn on, swollen battery
Some advice before you start
Repair - Repair guide: Battery iPhone 6S
Guide format : Pdf Integrate

Step 1

Before disassembling the battery of your iPhone 6S, you have to securely turn it off.

Maintain the power button on the top for a few seconds.

Then slide to the right to "power off" button in red.

Your iPhone 6S is now turned off.

Step 2

With a pentalobe screw driver, remove the two screws circled in red on the picture.

Those screws are on both side of the lightning connector of the phone.

Those two screws maintain the bottom part of the screen on the iPhone's frame.

Step 3

Then put the iSclack on the iPhone 6S.

The suction cups have to be near the home button (at the bottom) as shown on pictures 1 and 2.

Make sure the suction cups are perfectly attached to the iPhone and then close the handle of the iSclack to separate the suction cups, pulling the front panel up from the rear case.

A black seal on both sides of the phone and another white one at the top and bottom hold the display assembly to the rear panel.

Step 4

Then lift the display assembly to a 90° angle.

With a cruciform screwdriver, remove the five screws circled in red.

Those screws hold the display assembly connector bracket. You'll be able to remove in using tweezers in the next step.

Step 5

Use tweezers to remove the display assembly connector bracket.

Step 6

With a nylon spudger, gently pry to disconnect the following cables:

  • Front camera
  • Earpiece speaker
  • Proximity and light sensor
  • Touch screen/LCD screen

Step 7

Still using the spudger, pry again and disconnect the cable holding the display assembly to the iPhone 6S :

- Front camera

- Earpiece speaker

- Proximity and light sensor

-Home button.

Step 8

You can lift the display assembly and remove it.

The display assembly of the iPhone 6S is now disassembled.

Step 9

Use the cruciform screwdriver and remove the two screws circled in red that hold the vibrator.

Then remove it with a pair of tweezers.

Step 10

Use the cruciform screwdriver and remove the two screws circled in red holding the battery and dock connector bracket.

Step 11

With a pair of tweezers, grab the connector bracket and remove it.

Step 12

Then use the spudger again and disconnect the battery from the logic board.

Step 13

Then peel off the two black strips for the battery removal .

Step 14

Grab those two strips and gently pull them (see pictures).

Step 15

Use the nylon spudger to lift the battery.

Grab the battery and remove it.

Step 16

The battery of your iPhone 6S is now disassembled.

If your battery is defective, you can replace it with a new one.

To reassemble your iPhone 6S follow this guide in reverse order.

Comments

Add a comment

They're talking about us

SOSav in the press

  • SOSav on tf1
  • SOSav on france 2
  • SOSav on france 3
  • SOSav on m6
  • SOSav on france info
  • SOSav on 01 net
  • SOSav on l express