Spare parts for smartphones, tablets... English USD

Repair guide : Vibrator iPhone 6

Level : Easy Time : 25 min Author : Louis O.
165 people have done this repair successfully ! Why not you?
This is for replacing the vibrator on the iPhone 6.
Symptoms : vibrator that does not vibrate or makes an abnormal sound
Some advice before you start
Repair - Repair guide: Vibrator iPhone 6
Guide format : Pdf Integrate

Step 1

Before disassembling the vibrator of your iPhone 6, you have to securely turn it off.

Maintain the power button on the top for a few seconds.

Then slide to the right to "power off" button in red.

Step 2

The SIM card tray of the iPhone 6 can be found on the right side of the phone, near the power button (on/off/sleep).

Insert the SIM card eject tool in the small hole and push to eject the SIM tray.

Then grab it and remove it.

The iPhone 6 SIM card tray is now removed.

Step 3

With a pentalobe screw driver, remove the two screws circled in red on the picture.

Those screws are on both side of the lightning connector of the phone.

Those two screws maintain the bottom part of the screen on the iPhone's frame.

Step 4

Then put the iSclack on the iPhone 6.

The suction cups have to be as close as possible to the home button of the iPhone as shown on the picture for a better grip.

Make sure the suction cups are well fixed to the iPhone, then open the tweezers in order to separate the screen from the frame of the phone.

Step 5

With a cruciform screw, remove the five screws circled in red.

Those screws hold the front panel cable bracket that you can remove with a pair of tweezers.

Step 6

With a nylon spudger, gently pry up to disconnect the cable for :

   - the front camera,

   - the earpiece speaker,

   - the proximity and light sensor,

   - and the home button cable.

Step 7

Still with a nylon spudger, pry again to disconnect gently the last two cables holding the display assembly of your iPhone 6 :

   - the LCD screen cable,

   - the touch screen cable.

Step 8

You can lift the complete display assembly and remove it

The complete display assembly is now disassembled.

Step 9

For safety reason, you have to disconnect the battery from the logic board.

Use the cruciform screw again and remove the two screws circled in red.

Those screws maintain the 2 following connectors bracket :

              - battery connector,

              - headphone jack/speaker/lightning dock/microphone connector.

Then grab the connector's bracket with tweezers and remove it.

Step 10

Use the nylon spudger and gently pry to disconnect the battery cable.

We recommend that your unplug the battery for safety reason. But there's no need to remove it completely.

Step 11

With a cruciform screwdriver, remove the two screws circled in red.

Those screws maintain the vibrator to the rear panel.

You can now remove the vibrator using tweezers.

Step 12

The vibrator of your iPhone 6 is now disassembled.

You can replace it by a new one.

To reassemble your iPhone 6 follow this guide in reverse order.

Comments

Add a comment

They're talking about us

SOSav in the press

  • SOSav on tf1
  • SOSav on france 2
  • SOSav on france 3
  • SOSav on m6
  • SOSav on france info
  • SOSav on 01 net
  • SOSav on l express