Repair guide : Front Panel Assembly iPhone 6

Maintain the power button on the top for a few seconds.

The SIM card tray of the iPhone 6 can be found on the right side of the phone, near the power button (on/off/sleep).

Insert the SIM card eject tool in the small hole and push to eject the SIM tray.

Then grab it and remove it.

The iPhone 6 SIM card tray is now removed.

Those screws are on both side of the lightning connector of the phone.

Then put the iSclack on the iPhone 6.

The suction cups have to be as close as possible to the home button of the iPhone as shown on the picture for a better grip.

Make sure the suction cups are well fixed to the iPhone and peel the two suction cups off the iPhone.

With a nylon spudger, gently pry up to disconnect the cable for :

   - the front camera,

   - the earpiece speaker,

   - the proximity and light sensor,

   - and the home button cable.

Still with a nylon spudger, pry again to disconnect gently the last two cables holding the display assembly of your iPhone 6 :

   - the LCD screen cable,

   - the touch screen cable.

Then lift the complete display assembly and remove it.

The iPhone 6 screen is now partially disassembled.

Then use the pair of tweezers to grab and remove this home button bracket.

Still using the nylon spudger, gently pry up to disconnect the home button cable.

Then push aside the cable to the left as shown on picture 3.

Keep using the nylon spudger and gently peel off the home button cable.

Peel off the home button from its socket en keep using the nylon spudger.

With a pair of tweezers, grab and remove the home button.

The iPhone 6 somplete display assembly is now disassembled

You can replace it by a new one if needed.