Before replacing the LCD shield plate of your iPhone 5C, you have to securely turn it off..
Remove the two pentalobe screws on each side of the lightning connector.
To open your iPhone 5C, put the iSclack or a suction cup on the front panel.
With the iSclack : Put the iPhone in between the plastic suction cups. Close the handle, it will pull the front panel up from the rear.
With a suction cup : Put a suction cup above the home button. Then gently pull to lift the front panel of the iPhone 5C.
Make sure the suction cup is completely on the screen.
You can now open the display assembly vertically.
Do not remove completely the front panel, it is still attached to the logic board by a few cables.
Remove the 4 screws circled in red holding the cables to the logic board.
With a pair of tweezers, remove the panel assembly cable bracket from your iPhone 5C.
With a nylon spudger, disconnect the 3 connectors on the screen :
the first one is the cable to the front camera and the proximity sensor,
the second one is the touch screen cable,
The third one, is the LCD Retina cable.
You iPhone 5C's display assembly is now disassembled.
Remove the two screws circled in red holding the LCD shield on the right.
Remove the two screws circled in red holding the LCD shield on the left.
Remove the screw circled in red holding the LCD shield at the bottom.
Remove the three screws circled in red holding the LCD shield at the top as well ad the earpiece speaker bracket.
Insert the nylon spudger, between the bracket and the cable to free it .
Still with the nylon spudger, lift the earpiece speaker and remove it from its compartment.
Still using the nylon spudger, peel off the camera cable before removing it from its compartment.
With your fingers, lift the LCD shield plate.
With a nylon spudger, peel off the cable sticked to the LCD shield plate.
The LCD shield plate is now disassembled, you can replace it by a new one.
To reassemble your iPhone 5C follow this guide in reverse order.
Add a comment